UVS33/36
Log Installation UVS36
1.Remove window frame. (See "Window Frame" section)
2.Remove logs from packaging.
As with all plastic - these are not toys and should be kept away from children and infants.
3.Place rear log (BE8) on rear bracket (ensure log is seated properly, leveled and centered to the unit), so the log will not move form side to side and is firmly positioned onto the bracket.
4.Place front left log (BE6) on top of burner, left side. Use log's bottom holes to locate it onto the left bracket log locator studs.
5.Place front right log (BE7) on top of burner right side. Use log's bottom holes to locate it onto the left bracket log locator studs.
| Top Right Log |
Rear Log | (BE10) |
(BE8) | Top Left Log |
| (BE9) |
| Front Right Log |
Front Left Log | (BE7) |
(BE6) | LG131 |
Fig. 18 UVS36 log placement.
6.Place ember material on top of burner. (Refer to "Ember Material Placement").
7.Place top left log (BE9) onto locator notches. Ensure log is secure.
8.Place top right log (BE10) onto locator notches. Ensure log is secure.
Ember Material Placement
Separate the ember material into small pieces and place onto the burner in front of the front logs. Do NOT pack down, leave in fluffy, loose condition for most re- alistic ember effects. Do not install more embers on the burner than come with the unit.
Application of excess loose material may adversely affect performance of theheater.
Replacement loose embers must be purchased through authorized Majestic Fireplaces dealers.
WARNING: All previously applied loose material must be removed prior to reappli- cation.
Lava Rock
The lava rock provided with this fireplace must be placed on the firebox bottom on either side of the burner assembly. Do not place lava rock directly on burner. (Fig. 18)
Under no circumstances should this lava rock be placed on any part of the burner assembly.
First Firing
Upon completing your gas line connection, a small amount of air will be in the lines. When first lighting unit with pilot light, it will take a few minutes to purge themselves of this air. Once the purging is complete, the pilot and burner will light and operate as indicated in the instruction manual. Subsequent lightings of the heater will not require such purging.
Odor During Operation
Neither natural gas nor propane gas give off an odor when burned. The nature of a vent free combustion system, however, is such that odors may occasionally be produced during heater operation when impurities exist in the immediate area. Cleaning solutions, paint, solvents, cigarette smoke, candles, adhesives, new car- pet or textiles, etc., all can create fumes. These fumes may mix with combustion air and can create odor. Such odors will disappear over time, however, the condition can be alleviated by opening a window or otherwise providing additional ventilation to the area.
Flame Adjustment
For fireplaces equipped with HI/LO valves, flame ad- justment is accomplished by rotating the HI/LO adjust- ment knob located near the center of the gas control. (Fig. 18)
12 | 20002211 |
