Makita 3703 instruction manual Circular work

Circular work

0 Circular work may be accomplished if you assemble the straight guide and guide plate as shown in the figure below.

0 Min. and max. radius of circles to be cut (distance between the center of circle and the center of bit) are as follows :

Min. : 70 mm (2-3/4")

Max. : 221 mm (8-11/16")

(Note)

Circles between 172 mm (6-3/4") and 186 mm (7-5/16") in radius cannot be cut using this guide.

Wing nut

Wave washer

A	Flat washer
	Center hole	Center hole

Guide plate

Straight guide

Bolt

For cutting circles between 70 mm (2-3/4") and 121 mm (4-3/4") in radius.

Align the center hole in the straight guide with the center of the circle to be cut. Drive a nail less than 6 mm (1/4") in diameter into the center hole to secure the straight guide. Pivot the tool around the nail in clockwise direction.

For cutting circles between 121"	(4-3/4")
and 221 mm (8-11/16") in radius.

8