VOLTAGE WARNING: Before connecting the tool to a power source (receptacle, outlet, etc.) be sure the voltage supplied is the same as that specified on the nameplate of the tool. A power source with voltage greater than that specified for the tool can result in SERIOUS INJURY to the user-as well as damage to the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with voltage less than the nameplate rating is harmful to the motor.

ADDITIONAL SAFETY RULES

1, Avoid cutting nails. Inspect for and remove all nails from the workpiece be- fore operation.

2.Don't cut hollow pipe.

3.Do not cut oversize workpiece.

4.Check for the proper clearance beneaththe workpiece before cutting so that the blade will not strike the floor, workbench, etc.

5.Hold the tool firmly.

6.Make sure the blade is not contacting the workpiece before the switch is turned on.

7.Keep hands away from moving parts.

8.When cutting through walls, floors or wherever "live" electrical wires may be encountered, DO NOT TOUCH ANY METAL PARTS OF THE TOOL! Hold the tool only by the insulatedgrasping surfaces to prevent electric shock if you cut through a "live" wire.

9.Do not leave the tool running. Operate the tool only when hand-held.

IO.Always switch off and wait for the blade to come to a complete stop before removing the blade from the workpiece.

11.Do not touch the blade or the workpiece immediately after operation; they may be extremely hot and could burn your skin.

SAVE THESE INSTRUCTIONS.

4

Page 4
Image 4
Makita 4301BV instruction manual Additional Safety Rules