Bevel cutting
CAUTION:
Always remove the battery from the tool before making any adjustments
With the base tilted, you can make bevel cuts at any angle between 0" and 45" (left or right). Loosen the bolt on the bottom of the tool. Move the base so that the bolt is positioned in the center of the
Tilt the base until the desired bevel angle is obtained. The edge of the motor housing indicates the bevel angle by graduations. Then tighten the bolt to secure the base.
Flush cutting
Loosen the bolt on the bottom of the tool and slide the base all the way back. Then tighten the bolt to secure the base.
Edge of motor housing
r l I
11
