13
2. Circularcuts
Whencutting circles or arcs of 170 mm (6-11/16”) or less
in radius,install the rip fence as follows.
Insert the rip fence into the rectangular hole on the side
ofthe tool base with the fence guide facing up. Insert the
circular guide pin through either of the two holes on the
fence guide. Screw the threaded knob onto the pin to
secure the pin.
Nowslide the r ip fenceto the desired cutting radius, and
tighten the bolt to secure it in place. Then movethe tool
base allt he wayforward.
NOTE:
• Always use blades No. B-17, B-18, B-26 or B-27 when
cutting circlesor arcs.
Cover plate
Use the cover plate when cutting decorative veneers, plas-
tics, etc. It protects sensitive or delicate surfaces from dam-
age.Fit it on the back of the tool base.
Anti-splintering device
Forsplinter-free cuts, the anti-splintering device can be used.
To install the anti-splintering device,move the tool base all
the way forward and fit it from the backof tool base. When
you use the cover plate, install the anti-splintering device
onto the coverplate.
CAUTION:
• Theanti-splinter ing devicecannot be used when making
bevelcuts.
1. Fenceguide
2. Threaded knob
3. Circular guide pin
001951
1
2
3
001952
1. Coverplate
2. Base
1
2
001953
1. Base
2. Anti-splintering device
1
2
001954