11
B) Plunge cutting:
Youneednotboreastartingholeormakealead-incutif
youcarefully do as follows.
(1) Tilt the tool up on the front edge of the base, with
the blade point positioned just abovethe workpiece
surface.
(2) Apply pressure to the tool so that the front edge of
the base will not move when youswitch on the tool
and gently lowerthe back end of the tool slowly.
(3) Asthe blade pierces the workpiece, slowly lower the
base of the tool downonto the workpiece surface.
(4) Completet he cut in the normal manner.
Finishing edges
To trim edges or make dimensional adjustments, run the
bladelightly along the cut edges.
Metal cutting
Always use a suitable coolant (cutting oil) when cutting
metal. Failureto do so will cause significant blade wear. The
underside of the workpiece can be greased instead of using
acoolant.
Dust extraction
The dust nozzle (optional accessory) is recommended to
performclean cutting operations.
Toattach the dust nozzle on the tool, insert the hook of dust
nozzleinto the hole in the base.
001944
001945
1. Dust nozzle
2. Base
1
2
001946