5
5. Donot cut oversize workpiece.
6. Check for the proper clearance beyond
the workpiece before cutting so that the
blade will not strike the floor,workbench,
etc.
7. Holdthe tool firmly.
8. Make sure the blade is not contacting the
workpiecebefore the switch is turned on.
9. Keephands away from moving parts.
10. Donot leave the tool running. Operate the
toolonly when hand-held.
11. Alwaysswitch off and wait for the blade to
come to a complete stop beforeremoving
theblade from the workpiece.
12. Do not touch the blade or the workpiece
immediately after operation; they may be
extremelyhot and could burn your skin.
13. Some material contains chemicals which
may be toxic. Take caution to prevent
working dust inhalation and skin contact.
Followmaterial supplier safety data.
SAVE THESE INSTRUCTIONSWARNING:
MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
SYMBOLS USD201-2
The followingsshow the symbols used for tool.
V.......................volts
A.......................amperes
Hz..................... hertz
................alternating current
....................no load speed
....................Class II Construction
.../min................revolutions or reciprocation per
minute