
Installing or removing/adjustment of rasp blade and holder
CAUTION:
0 Always be sure that the tool i s switched off and the battery cartridge is removed before installing or removing/adjustment of the rasp blade and holder.
0 Always be sure that all bolts which secure the rasp blade or holder are securely tightened before use.
1. Use an 82 mm x 25 mm x 3 mm rasp |
|
blade which is available on the market. | Rasp |
2. To install the rasp blade, slide into the |
|
holder up to the stop and tighten both |
|
securing bolts using the hex wrench. |
|
| Securing bolt | |
| Hex wrench i Tighten | |
3. The holder is held on the drive shaft |
| |
with the rasp blade facing upward. If | Drive shaft | |
you wish to | ||
| ||
drive shaft with the rasp blade facing | Securing bolt | |
downward, proceed as follows. |
|
i)Loosen the securing bolt using the hex wrench and pull the holder out of the drive shaft.
ii)Turn the holder upside down and
insert it into the drive shaft. | Hex wrench | I | |
iii) Tighten the securing bolt using the | |||
|
hex wrench after aligning the securing bolt with the notch on the drive shaft.
4.In normal use the holder is used in the flat position: for the first premolar the holder is angled, The holder is activated by pressing the spring loaded trigger and moving to the position required and then releasing the trigger.
vTI
7