7.TUNER CONTROL
(for use with NAD Tuner)
BANK Selects a bank of preset stations.
PRESET or selects respectively higher or lower number station preset.
8.CD PLAYER CONTROL
(for use with NAD CD Player) engages Pause
engages Stop
engages Play or toggles between Play and Pause
or engages Track skip; Press once to respectively go to the next track or to return to start of current or previous track. NEXT DISC Go to next disc (for NAD CD changers).
9. CASSETTE DECK CONTROL
(for use with single (DECK B) or double transport (A and B) NAD Cassette Decks).
or engages Forward Play or Reverse Play.
Record / Pause. Press to put cassette deck into record- pause. Press Play to start recording.
Stops Play or Recording.
engages Rewind. engages Fast Forward.
NOTES: The remote control handset supplied with the C370 is of a universal NAD type, designed to operate several NAD models. Some buttons on this handset are inoperative as the functions aren't supported by the C370. The Video 2 and Video 3 input selector buttons (inside section No. 5) on the remote control handset are inoperative in the case of the C370.
Direct sunlight or very bright ambient lighting may affect the operating range and angle for the remote control handset.
TROUBLESHOOTING
Problem | Cause | Solution |
|
|
|
NO SOUND | • Power AC lead unplugged or power not | • Check if AC lead is plugged in and |
| switched on | power switched on |
| • Tape 1 Monitor selected | • |
| • Mute on | • Switch off Mute |
| • Rear | • Fit links |
| • No speakers selected | • Select the appropriate speakers (A / B) |
|
|
|
NO SOUND ONE CHANNEL | • Balance control not centred | • Centre Balance control |
| • Speaker not properly connected | • Check connections and speakers |
| or damaged. |
|
| • Input lead disconnected or damaged | • Check leads and connections |
|
|
|
WEAK BASS / | • Speakers wired out of phase | • Check connections to all speakers in |
DIFFUSE OR NO STEREO IMAGE |
| the system |
| • Bridge Mode selected when speakers | • Disengage Bridge Mode |
| are connected normally |
|
|
|
|
REMOTE CONTROL HANDSET NOT | • Batteries flat, or incorrectly inserted | • Check or replace batteries |
WORKING | • IR transmitter or receiver windows | • Remove obstruction |
| obstructed |
|
| • IR receiver in direct sun or very bright | • Place unit away from direct sun, reduce |
| ambient light | amount of ambient light |
|
|
|
POWER/PROTECTION LED STAYS RED | • Loudspeakers cabling has a short- | • Turn amplifier off and check |
UPON TURNING POWER ON | circuit | loudspeaker cable connections for both |
|
| speakers at amplifier's back panel and |
|
| loudspeakers. Turn amplifier on. |
|
|
|
POWER/PROTECTION INDICATOR TURNS | • Amplifier has | • Turn amplifier off. Make sure |
RED DURING OPERATION | • Overall impedance of loudspeakers too | ventilation slots on top and bottom of |
| low | amplifier aren't blocked. After amplifier |
|
| has cooled down, turn back on. |
|
| • Ensure the overall loudspeaker |
|
| impedance isn't below 4 ohms. |
|
| • Check loudspeaker cables for short |
|
| circuits |
|
|
|
GB
9