Installing the side grip
For your own safety, always use the side grip. Install it by screwing it firmly on the grip holder. The side grip can be pivoted for easy operation. See the figure a t right.
Side grip can pivoted
Grip holder
Installing or removing the abrasive belt
CAUTION :
Always be sure that the tool is switched off and unplugged before installing or removing the belt.
Loop the belt over the front pulley. Hold the tool as shown a t right and press down to retract the front pulley so that you can slip the other end of the belt over the rear pulley. When pressing down the tool, be careful not to allow the front pulley to turn unexpectedly, causing you to lose control of the tool.
NOTE : |
|
The arrow on the inside of the belt and | Arrow |
that marked on the rear pulley must point | |
in the same direction. |
5
