Makita 9566CV instruction manual Installing or removing wheel guard, wheel/Multi-disc

002980

1

2

3 4

1.Wheel guard

2.Bearing box

3.Screw

4.Lever

002981

1

1. Screw

Installing or removing wheel guard

CAUTION:

•When using a depressed center grinding wheel/Multi- disc, flex wheel, wire wheel brush or cut-off wheel, the wheel guard must be fitted on the tool so that the closed side of the guard always points toward the operator.

Loosen the lever on the wheel guard. Mount the wheel guard with the protrusion on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard around 180 degrees. Tighten the lever to fasten the wheel guard. If the lever is too tight or too loosen to fasten the wheel guard, loosen or tighten the screw to adjust the tight- ening of the wheel guard band.

To remove wheel guard, follow the installation procedure in reverse.

002982	Installing or removing depressed center grinding
1	wheel/Multi-disc
2

3 WARNING:

	4	• Always use supplied guard when depressed center
		grinding wheel/Multi-disc is on tool. Wheel can shatter
		during use and guard helps to reduce chances of
1.	Lock nut	personal injury.
2.	Depressed center grinding wheel/ Mount the inner flange onto the spindle. Fit the wheel/disc on
	Multi-disc	the inner flange and screw the lock nut onto the spindle.

3.Inner flange

4.Spindle

1

2

1.Lock nut wrench

2.Shaft lock

002390 To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise.

To remove the wheel, follow the installation procedure in reverse.

8