Makita 9566CV Operation, Installing or removing abrasive disc optional accessory

001107

1

2

3

1.Lock nut

2.Abrasive disc

3.Rubber pad

001618

1

2

3

4

1.Lock nut

2.Abrasive cut-off wheel

3.Inner flange

4.Wheel guard for cut-off wheel

OPERATION

Installing or removing abrasive disc (optional accessory)

NOTE:

•Use sander accessories specified in this manual. These must be purchased separately.

Mount the rubber pad onto the spindle. Fit the disc on the rubber pad and screw the lock nut onto the spindle. To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise.

To remove the disc, follow the installation procedure in reverse.

Installing or removing abrasive cut-off wheel (optional accessory)

WARNING:

•When using an abrasive cut-off wheel, be sure to use only the special wheel guard designed for use with cut- off wheels.

•NEVER use cut-off wheel for side grinding.

During cutting operations, never change the angle of the wheel. Placing side pressure on the cut-off wheel (as in grinding) will cause the wheel to crack and break, causing serious personal injury.

WARNING:

•It should never be necessary to force the tool. The weight of the tool applies adequate pressure. Forcing and excessive pressure could cause dangerous wheel breakage.

•ALWAYS replace wheel if tool is dropped while grinding.

•NEVER bang or hit grinding disc or wheel onto work.

•Avoid bouncing and snagging the wheel, especially when working corners, sharp edges etc. This can cause loss of control and kickback.

•NEVER use tool with wood cutting blades and other sawblades. Such blades when used on a grinder frequently kick and cause loss of control leading to personal injury.

9