| 002983 |
A | B |
CAUTION:
•After operation, always switch off the tool and wait until the wheel has come to a complete stop before putting the tool down.
Grinding and sanding operation
ALWAYS hold the tool firmly with one hand on housing and the other on the side handle. Turn the tool on and then apply the wheel or disc to the workpiece.
In general, keep the edge of the wheel or disc at an angle of about 15 degrees to the workpiece surface.
During the
001136
1
1. Wire cup brush
002984
1
1. Wire wheel brush
10
Operation with wire cup brush (optional accessory)
CAUTION:
•Check operation of brush by running tool with no load, insuring that no one is in front of or in line with brush.
•Do not use brush that is damaged, or which is out of balance. Use of damaged brush could increase potential for injury from contact with broken brush wires.
Unplug tool and place it upside down allowing easy access to spindle. Remove any accessories on spindle. Thread wire cup brush onto spindle and tighten with supplied wrench. When using brush, avoid applying too much pressure which causes over bending of wires, leading to premature break- age.
Operation with wire wheel brush (optional accessory)
CAUTION:
•Check operation of wire wheel brush by running tool with no load, insuring that no one is in front of or in line with the wire wheel brush.
•Do not use wire wheel brush that is damaged, or which is out of balance. Use of damaged wire wheel brush could increase potential for injury from contact with broken wires.