Installing or removing wheel
1 | 2 | |
3 | ||
|
4
004568
1.Spindle
2.Wheel
3.Output shaft
4.Hex wrench
OPERATION
1 | 2 | 1. Grip | |
2. Handle | |||
|
| ||
|
|
|
To remove the wheel, insert one hex wrench into the end of the spindle and another hex wrench into the end of the output shaft. Turn the hex wrench in the output shaft clockwise while securely holding the hex wrench in the spindle so that the wheel cannot revolve. Pull the output shaft out from the wheel. Move the wheel slightly away from the spindle and remove the wheel from the tool.
NOTE:
•The output shaft has a left hand thread.
To install the wheel, follow the removal procedures in reverse. When installing it, be sure to align the notches in the wheel with the pins on the spindle.
1 | 2 | 1. | Notch |
2. Wheel | |||
|
| 3. | Spindle |
|
| 4. | Pin |
3 |
|
|
|
4 |
|
|
|
004569 |
|
|
|
Connecting to dust collector
004571
Hold the tool firmly with both hands on the handle and the grip in front. Place the tool on the workpiece surface and move the tool gently forward and backward while applying slight downward pressure.
CAUTION:
•The tool should not be in contact with the workpiece surface when you turn the tool on or off. Damage to the tool or the workpiece surface and injury to the operator may result.
•Apply slight downward pressure only. Excessive pressure may decrease tool efficiency, shorten wheel service life and possibly gouge the workpiece surface.
MAINTENANCE
CAUTION:
•Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
•Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.
2 1
3
004570
1.Dust port
2.Cover plate
3.Joint
Replacing carbon brushes
1. Limit mark
1
The use of a dust collector makes sanding operations clean and dust collection easy. To connect a dust collector, open the dust port by sliding the cover plate up and in a clockwise direction. Attach the joint onto the dust port. Now a dust collector can be connected to this tool.
CAUTION:
•When not using a dust collector, close the dust port opening with the cover plate.
001145
Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes.
5
