Makita AN611 instruction manual Nose adapter, Loading nailer

Nose adapter

CAUTION:

Always lock the trigger and disconnect the hose before installing or removing the nose adapter.

When nailing workpieces with easily-marred surfaces, use the nose adapter. It is factory installed at the rear of the tool.

Nose piece storing portion

Attach the nose adapter to the contact arm (see right). When not in use, store the nose adapter at the rear of the tool to keep it from being lost.

Loading nailer

CAUTION:

Contact arm

\

Nose adapter a-t

I

Always lock the trigger and disconnect the hose before loading the nailer.

Select nails suitable for your work. Depress the latch lever and open the door and magazine cap.

Lift and turn the coil support plate to set it to the correct step. When loading 57 or 65 mm (2-1/4”, 2-1/2”) long nails, use the bottom step. When loading 45 or 50 mm (1-3/4”, 2”) long nails, use the middle step. When loading 32 or 38 mm (1-1/4”, 1-1/2”) long nails, use the top step. If the tool is operated with the coil support plate set to the wrong step, poor nail feed or malfunction of the tool may result.

I

Coil support plate

12