To remove the blade, press the shaft lock so that the blade cannot revolve and use the wrench to loosen the hex bolt clockwise. Then remove the hex bolt, outer flange and blade.
To install the blade, follow the removal procedure in reverse. BE SURE TO TIGHTEN THE HEX BOLT COUNTERCLOCKWISE SECURELY.
|
|
| 1. Inner flange |
2 |
|
| 2. Saw blade |
| 4 | 3. Outer flange | |
|
| ||
| 3 | 4. Hex. bolt | |
|
| ||
|
|
| |
1 |
|
|
|
006707 |
|
|
|
When changing blade, make sure to also clean upper and lower blade guards of accumulated sawdust. Such efforts do not, however, replace the need to check lower guard operation before each use.
1. Hose
2. Vacuum cleaner
1
2
006712
When you wish to perform clean cutting operation, connect a Makita vacuum cleaner to your tool. Install the dust nozzle on the tool using the screw. Then connect a hose of the vacuum cleaner to the dust nozzle as shown in the figure.
OPERATION
CAUTION: |
• Always insert the battery cartridge all the way until |
it locks in place. If you can see the red part on the |
Hex wrench storage
1 |
006708 |
1. Hex wrench
| upper side of the button, it is not locked completely. | |
| Insert it fully until the red part cannot be seen. If not, | |
| it may accidentally fall out of the tool, causing injury | |
| to you or someone around you. | |
• | Be sure to move the tool forward in a straight line | |
| gently. Forcing or twisting the tool will result in | |
| overheating the motor and dangerous kickback, | |
| possibly causing severe injury. | |
• | If the tool is operated continuously until the battery | |
| cartridge has discharged, allow the tool to rest for | |
| 15 minutes before proceeding with a fresh battery. | |
|
| 1. Rear handle |
When not in use, store the hex wrench as shown in the figure to keep it from being lost.
Connecting a vacuum cleaner
1 | 2 | 2. | Front grip |
|
| ||
|
| 3. | Base |
1 
2
006711
1.Dust nozzle
2.Screw
3 |
006709 |
Hold the tool firmly. The tool is provided with both a front grip and rear handle. Use both to best grasp the tool. If both hands are holding saw, they cannot be cut by the blade. Set the base on the workpiece to be cut without the blade making any contact. Then turn the tool on and wait until the blade attains full speed. Now simply move the tool forward over the workpiece surface, keeping it flat and advancing smoothly until the sawing is completed.
9
