14
MAKITA HP 100 high-performance two-stroke engine oil is
available in the following sizes to suit your individual require-
ments:
0,5 l Best.-Nr. 980 008 609
MAKITA high-performance two-stroke engine oil (50:1) is
available in the following sizes to suit your individual require-
ments:
1 l Best.-Nr. 980 008 607
100 ml Best.-Nr. 980 008 606
NOTE: For preparing the fuel-oil mixture first mix the entire oil
quantity with half of the fuel required, then add the remaining
fuel. Shake the finished mixture thoroughly before pouring it
into the Power Cut tank.
Caution: Open the tank cap carefully, as pressure might
have built up inside!
It is not wise to add more engine oil than specified to
ensure safe operation. This will only result in a higher
production of combus-tion residues which will pollute
the environment and clog the exhaust channel in the
cylinder as well as the muffler. In addition, fuel consump-
A

Refuelling

IMPORTANT:

FOLLOW THE SAFETY PRECAUTIONS!

Be careful and cautious when handling fuels.
The engine must be turned off and cooled down!
Carefully clean the area around the fuel-tank filler neck to
keep dirt from getting in the tank.
Place the unit on its side on an even surface.
Unscrew the tank cap and fill tank with fuel mixture. Take care
to avoid spilling.
Tightly screw on the cap.
Clean screw cap and tank after refuelling. Never start or
operate the Power Cut in the same place as it was fuelled!

Starting the engine

This model features a semiautomatic starting valve (1) to make
starting easier. Pushing this valve in reduces the amount of
compression effort needed, so that it is easier to bring the engine
up to starting speed when pulling the starter cable.
The high pressure increase in the combustion chamber that
results from the first ignitions will automatically close the
starting valve (button pops back out).
STOP
Fuel mixture
B
C
1
if
necessary
tion will rise and performance will decrease.

Fuel storage

Fuels have only a limited shelf-life. Buy only as much as you
will use in 4 weeks.
Store fuel only in approved and marked containers.

AVOID SKIN AND EYE CONTACT

Mineral oil products degrease your skin. If your skin comes in
contact with these substances repeatedly and for an ex-
tended period of time, it will desiccate. Various skin deseases
may result. In addition, allergic reactions are known to occur.
Eyes can be irritated by contact with oil. If oil comes into your
eyes, immediately wash them with clear water.
If your eyes are still irritated, see a doctor immediately!