1. Releasing cover
1
010489
If the bit cannot be pushed in, remove the bit. Pull the releasing cover down a couple of times. Then insert the bit again. Turn the bit and push it in until it engages.
010490 |
After installing, always make sure that the bit is securely held in place by trying to pull it out.
1. Releasing cover
1
010491
To remove the bit, pull the releasing cover down all the way and pull the bit out.
010493 |
The bit can be secured at 12 different angles. To change the bit angle, slide the change ring forward, then turn the change ring to change the bit angle. At the desired angle, slide the change ring back to the original position. The bit will be secured in place.
NOTE:
•The change ring cannot turn when the bit is not installed on the tool.
OPERATION
Chipping/Scaling/Demolition
010495
Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. Pressing very hard on the tool will not increase the efficiency.
Bit angle
1 |
010492 |
1. Change ring
MAINTENANCE
CAUTION:
•Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
•Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.
Lubrication
CAUTION:
•This servicing should be performed by Makita Authorized or Factory Service Centers only.
6
