This tool requires no hourly or daily lubrication because it has a
11. Screws
010458
Run the tool for several minutes to warm it up. Switch off and unplug the tool.
Loosen the four screws and remove the handle. Note that the top screws are different from other screws.
Wipe out the old grease inside and replace with a fresh grease (30 g). Use only Makita genuine hammer grease (optional accessory). Filling with more than the specified amount of grease (approx. 30 g) can cause faulty hammering action or tool failure. Fill only with the specified amount of grease.
CAUTION:
•Be careful not to damage the connector or lead wires especially when wiping out the old grease.
To reassemble the tool, follow the disassembling procedure in reverse.
CAUTION:
•Do not tighten the crank cap excessively. It is made of resin and is subject to breakage.
•Be careful not to damage the connector or lead wires especially when installing the handle.
1. Connector
1
010457
3
2
1.Connector
2.White
3.Black
2. White
3. Black
3
1 2
010461
Connect the connector firmly and then reinstall the handle.
Disconnect the connector by pulling them.
1. Crank cap cover
2. Screwdriver
2
1
010459
Loosen the four screws on crank cap and remove the crank cap cover.
1. Grease
1
010460
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
•Bull point
•Cold chisel
•Scaling chisel
•Clay spade
•Bit grease
•Safety goggles
•Hammer grease
•Plastic carrying case
7
