HAMMER SAFETY WARNINGS
1. | Wear ear protectors. Exposure to noise can |
| cause hearing loss. |
2. | Use auxiliary handle(s), if supplied with the |
| tool. Loss of control can cause personal injury. |
3. | Hold power tool by insulated gripping |
| surfaces, when performing an operation where |
| the cutting accessory may contact hidden |
| wiring or its own cord. Cutting accessory |
| contacting a "live" wire may make exposed metal |
| parts of the power tool "live" and could give the |
| operator an electric shock. |
4. | Wear a hard hat (safety helmet), safety glasses |
| and/or face shield. Ordinary eye or sun |
| glasses are NOT safety glasses. It is also |
| highly recommended that you wear a dust |
| mask and thickly padded gloves. |
5. | Be sure the bit is secured in place before |
| operation. |
6. | Under normal operation, the tool is designed |
| to produce vibration. The screws can come |
| loose easily, causing a breakdown or accident. |
| Check tightness of screws carefully before |
| operation. |
7. | In cold weather or when the tool has not been |
| used for a long time, let the tool warm up for a |
| while by operating it under no load. This will |
| loosen up the lubrication. Without proper |
| |
8. | Always be sure you have a firm footing. |
| Be sure no one is below when using the tool in |
WARNING:
DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product.
MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury.
Symbols
The followings show the symbols used for tool.
･volts
･amperes
･hertz
･ alternating current
･ Class II Construction
･ revolutions or reciprocation per minute
･ number of blow
FUNCTIONAL DESCRIPTION
CAUTION:
•Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool.
| high locations. |
9. | Hold the tool firmly with both hands. |
10. | Keep hands away from moving parts. |
11. | Do not leave the tool running. Operate the tool |
| only when |
12. | Do not point the tool at any one in the area |
| when operating. The bit could fly out and |
| injure someone seriously. |
13. | Do not touch the bit or parts close to the bit |
| immediately after operation; they may be |
| extremely hot and could burn your skin. |
14. | Do not operate the tool at |
Switch action
OFF |
ON |
1 |
010454 |
1. Switch lever
unnecessarily. |
15. Some material contains chemicals which may |
be toxic. Take caution to prevent dust |
inhalation and skin contact. Follow material |
supplier safety data. |
SAVE THESE INSTRUCTIONS.
CAUTION:
•Before plugging in the tool, always check to see that the tool is switched off.
•Switch can be locked in "ON" position for ease of operator comfort during extended use. Apply caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, push the switch lever "ON (I)" on the left side of the tool. To stop the tool, push the switch lever "OFF (O)" on the right side of the tool.
4
