Makita HM1202C instruction manual Accessories

Center for this lubrication service.

Run the tool for several minutes to warm it up. Switch off and unplug the tool.

Loosen the six screws and remove the handle.

1. Screws

1

002967

Remove the crank cap using a socket wrench. Rest the tool on the table with the bit end pointing upwards. This will allow the old grease to collect inside the crank housing.

1	1.	Socket wrench
	2.	Crank cap
	2

To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.

ACCESSORIES

CAUTION:

• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.

If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.

•Bull point (SDS-max)

•Cold chisel (SDS-max)

•Scaling chisel (SDS-max)

•Clay spade (SDS-max)

•Bit grease

•Hammer grease

•Safety goggles

•Plastic carrying case

002968

Wipe out the old grease inside and replace with a fresh grease (30 g; 1 oz). Use only Makita genuine hammer grease (optional accessory). Filling with more than the specified amount of grease (approx. 30 g; 1 oz) can cause faulty hammering action or tool failure. Fill only with the specified amount of grease.

1

1. Hammer grease

002969

Reinstall the crank cap and tighten with the socket wrench.

CAUTION:

•Do not tighten the crank cap excessively. It is made of resin and is subject to breakage.

•Be careful not to damage the terminals or lead wires especially when wiping out the old grease or installing the handle.

7