Makita HR2475X2 instruction manual Assembly

position (B side) for counterclockwise rotation.

Selecting action mode

CAUTION:

•Always set the knob fully to your desired mode symbol. If you operate the tool with the knob positioned half-way between the mode symbols, the tool may be damaged.

•Do not rotate the action mode changing knob when the tool is running under load. The tool will be damaged.

•To avoid rapid wear on the mode change mechanism, be sure that the action mode changing knob is always positively located in one of the three

action mode positions.

Rotation with hammering

1	2	1.	Lock button
		2.	Rotation with
			hammering
		3. Action mode
			changing knob
		3
010158

For drilling in concrete, masonry, etc., depress the lock button and rotate the action mode changing knob to the symbol. Use a tungsten-carbide tipped bit.

Hammering only

1	1. Hammering only
010160

For chipping, scaling or demolition operations, depress the lock button and rotate the action mode changing

knob to the symbol. Use a bull point, cold chisel, scaling chisel, etc.

Rotation only

For drilling in wood, metal or plastic materials, depress the lock button and rotate the action mode changing

knob to the symbol. Use a twist drill bit or wood bit.

Torque limiter

The torque limiter will actuate when a certain torque level is reached. The motor will disengage from the output shaft. When this happens, the bit will stop turning.

CAUTION:

•As soon as the torque limiter actuates, switch off the tool immediately. This will help prevent premature wear of the tool.

•Hole saws cannot be used with this tool. They tend to pinch or catch easily in the hole. This will cause the torque limiter to actuate too frequently.

ASSEMBLY

CAUTION:

•Always be sure that the tool is switched off and unplugged before carrying out any work on the tool.

Side handle (auxiliary handle)

	1		1. Grip base
			2. Tighten
		2	3. Loosen
			4. Teeth
			5. Side grip
			6. Protrusion
4	3
			6
5
010161

Always use the side grip to ensure operating safety. Install the side grip so that the teeth on the grip fit in between the protrusions on the tool barrel. Then tighten the grip by turning clockwise at the desired position. It may be swung 360° so as to be secured at any position.

Bit grease

Coat the bit shank head beforehand with a small amount of bit grease (about 0.5 - 1 g).

This chuck lubrication assures smooth action and longer service life.

Installing or removing the bit

1 1. Rotation only

1

2

1.Bit shank

2.Bit grease

010159

009664

5