Makita LS1040S instruction manual Accessories, After use, Replacing carbon brushes

		1. Arm
		2.	Bevel scale
		3.	Pointer
		4. Turn base
		4
1	2	3
001769

12

001772

1.Screwdriver

2.Brush holder cap

(2)45° bevel angle

1	4
2
	3
001770

1.Lever

2.Arm

3.Pointer

4.45 ﾟ bevel angle adjusting bolt

After use

•After use, wipe off chips and dust adhering to the tool with a cloth or the like. Keep the blade guard clean according to the directions in the previously

covered section titled "Blade guard". Lubricate the sliding portions with machine oil to prevent rust.

To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts.

Adjust the 45° bevel angle only after performing 0° bevel angle adjustment. To adjust left 45° bevel angle, loosen the lever and tilt the blade to the left fully. Make sure that the pointer on the arm points to 45° on the bevel scale on the arm. If the pointer does not point to 45°, turn the 45° bevel angle adjusting bolt on the left side of the arm until the pointer points to 45°.

ACCESSORIES

CAUTION:

• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.

If you need any assistance for more details regarding

Replacing carbon brushes

1

001145

1. Limit mark

these accessories, ask your local Makita Service Center.

• Steel & Carbide-tipped saw blades

• Auxiliary plate

• Vise assembly (Horizontal vise)

• Vertical vise

• Socket wrench 13

• Holder set

• Holder assembly

• Holder rod assembly

• Set plate

• Dust bag

• Triangular rule

Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.

• Lock-off button (2 pcs.)

14