003470 Fit the wool bonnet completely over the rubber pad and pull the string tight. Tie a bow knot and tuck the knot and any loose strings between the wool bonnet and the rubber pad.
To remove the wool bonnet, follow the installation procedure in reverse.
003414
1
2
3
4
1.Lock nut
2.Abrasive disc
3.Rubber pad
4.Spindle
003418
1
2
1.Lock nut wrench
2.Wrench
Installing or removing abrasive disc (optional accessory)
NOTE:
•Use sander accessories specified in this manual. These must be purchased separately.
Mount the rubber pad onto the spindle. Fit the abrasive disc on the rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, hold the spindle with the wrench so that it cannot revolve, then use the lock nut wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in reverse.
OPERATION
003479
Polishing operation by sponge pad
CAUTION:
•Always wear safety glasses or a face shield during operation.
In general, keep the sponge pad at an angle of about 15 degrees to the workpiece surface.
10
