ENGLISH (Original instructions)
Explanation of general view
Lock button | Lock nut wrench | ||||
Switch trigger | Shaft lock | Brush holder cap | |||
Speed adjusting dial | Exhaust vent | Screwdriver | |||
Lock nut | Inhalation vent |
|
|
SPECIFICATIONS
Model | SA7000C |
Disc diameter | 180 mm |
Spindle thread | M14 |
No load speed (n0) / Rated speed (n) | 0 - 1,500 / 4,000 |
Overall length | 453 mm |
Net weight | 3.4 kg |
Safety class | /II |
•Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
•Specifications may differ from country to country.
•Weight according to
Intended use
The tool is intended for the sanding of large surface of wood, plastic and metal materials as well as painted surfaces.
Power supply
The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on
For European countries only
Noise
The typical
Sound pressure level (LpA) : 88 dB(A)
Sound power level (LWA) : 99 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value
Work mode: disc sanding
Vibration emission (ah,SG) : 2.5 m/s2 or less
Uncertainty (K) : 1.5 m/s2
If the tool is used for other applications, the vibration emission value may be different.
•The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another.
•The declared vibration emission value may also be used in a preliminary assessment of exposure.
WARNING:
•The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used.
•Be sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time).
EC Declaration of Conformity
We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s):
Designation of Machine:
Angle Sander
Model No./ Type: SA7000C are of series production and
Conforms to the following European Directives: 98/37/EC until 28th December 2009 and then with 2006/42/EC from 29th December 2009
And are manufactured in accordance with the following standards or standardised documents:
EN60745
3