Makita UML2OOD, UMLZOODW specifications Installing or removing battery cartridge, Charging

Installing or removing battery cartridge

0 Always switch off the tool before insertion or removal of the battery cartridge.

.To remove the battery cartridge, pull out the set plate on the bottom of the tool and grasp both sides of the cartridge while withdrawing it from the barrel.

.To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Snap the set plate back into place. Be sure to close the set plate fully before using the tool.

0 Do not use force when inserting the battery cartridge.

I f the cartridge does not slide in easily, it is not being inserted correctly.

Charging

.Plug the fast charger into your power source. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the fast charger. insert cartridge fully into the port so that it rests on the charger port floor.

Fig. 1

CAUTION :

.Your new battery cartridge is not charged. You will need to charge it before use.

0 I f you try to charge a cartridge from a just-operated tool, sometimes the charging light will not come on after you insert a cartridge from a just operated tool. L e t the cartridge cool off for a while. Then re-insert it and try to charge it once more.

0 If you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.

6