ASSEMBLY
Replacement of blades
CAUTION:
*Always be sure that the tool is switched off and unplugged before replacement of the
blades.
Removing cutting head
Use the hex wrench to loosen the three
Never remove the blades with bare hands. WearOtherwisegloves.it can cause injury.
screws which secure the cutting head. Pull Cutting head the cutting head straight out to remove it
with turning it left and right alternately.
Screws
'Hex wrench
Removing shear blades
Remove the three screws which hold the cutting head. When removing the second screw, be careful not to fall the sleeve. Then the blades can be removed easily. When removing the blades, hold the blades and the sleeve so that they do not fall from the cutting head.
Installing shear blades |
|
Install the sleeve and tighten th. three |
|
screws after inserting the center blade, |
|
side blade L & R into the cutting head. In |
|
this process, the screw heads should be |
|
protruding 2 - 3 mm from the cutting head |
|
surface. If you will tighten the screws |
|
excessively, the cutting head cannot be | Screws |
installedto the tool. | |
| Side blade L |
| Center blade |
| Side blade R |
6