Diagrams are representational

 

 

of the entire line of MANHATTAN

 

 

docking kits and may not depict

SATA Connector

Power Connector

specific cables/connectors.

Mounting a Drive in the Drive Case

These steps are for installing a 3.5-inch drive device in the drive case.

NOTE: A special adapter kit is required in order to install a 2.5-inch drive.

1.Remove the drive case cover by sliding it toward the back of the unit.

2.If you plan to install a drive that features removable media, carefully punch out the center part of the front panel.

IMPORTANT: If you are installing a new hard drive in the case, you may need to configure the drive before you

install it. Refer to the drive manufacturer’s documentation and configure the

drive as Master, Cable Select or Slave depending on the configuration of your computer. After you complete this

installation, you may also need to re-configure the computer’s BIOS setup to make the

drive functional in the system.



Page 5
Image 5
Manhattan Computer Products 451109, 451123 user manual Mounting a Drive in the Drive Case, Drive functional in the system