Installation Instructions Section 2
2-2 Part Number 14514 2/08
Uncrating
1. Remove the bottom shipping skid using one of the
methods below:
- Lay the cabinet on its back, elevated and
supported by wooden blocks. Remove the skid
mounting bolts and separate the skid from the
cabinet.
- Tilt the cabinet from side to side and remove the
mounting bolts. Support the weight of the cabinet
apart from the skid.
2. Install the legs or casters and torque them to
360 inch-pounds (41 Nm). Refer to the drawing at
right.
3. Return the cabinet to the upright position.
4. Remove any remaining crating materials. Installing Cabinet Legs
Leveling the Cabinet
The cabinet must be leveled after it is positioned in its
permanent location. This insures proper door alignment
on all cabinets, adequate condensate water drainage
and proper refrigeration system operation.
1. Move the cabinet to its permanent location.
2. Place a level on top of the cabinet.
3. Turn the leveling foot of the lowest corner leg to
center the bubble in the level.
4. Adjust each of the other corners until the bubble is
centered and the cabinet is stable.
5. Re-check the cabinet from side to side and from
front to rear with the level.
!
Warning
Never attempt to tilt the cabinet alone. Always use
two or more people when tilting the cabinet to
remove the shipping skid or to move it through
doorways.
!
Caution
If the cabinet was placed on its back while moving it
or while removing the bottom shipping skid, wait at
least two hours after returning the cabinet to the
upright position before starting the refrigeration
system.
!
Caution
Never use sharp instruments to cut the plastic or
cardboard crating materials. Damage to the cabinet
exterior may result.
!
Caution
If casters are installed instead of legs, the floor must
be leveled before final positioning of the cabinet.
Thread Foot in
as Far as
Possible
Thread Leveling
Leg into Base of
Cabinet
SV1342