Manitowoc Ice installation instructions K00117 Adapter KIT, Installation Instructions

K00117 ADAPTER KIT

Installation Instructions

1.Use the K00117 to install a 22" B, J, Q, S, and Flaker/Chip ice machines on a Manitowoc C-730 bin.

2.Installation (bin to be level before starting):

A.Remove the hinge on the right and left side of the bin.

B.Remove the foam tape on the right and left rail. Trim back the foam tape on the front and rear bin rails, as shown.

C.Position the adapter panels and hinges on bin and fasten with the four existing hinge screws.

D.Using the adapters as templates, drill four 5/32” (4 mm.) holes, .500” (12.7 mm.) deep maximum, in the rear of the bin (adapters must be level with bin). Warning: Do not drill through interior liner. Attach with the screws provided.

E.Apply foam tape to the edge of the adapters, as shown. Note: We recommend using RTV at intersections and along front inside edge of foam tape to prevent water tracking. Use double thickness with S-series ice machines.

3.Refer to ice machine installation manual for ice machine installation procedures.

22.00"

Ice
Machine	Existing two screws
Back
	Hinge
Trim back existing	Foam tape from kit - (trim to
foam tape 11 3/16”
	fit) two places - double tape
from outer edge of bin
	thickness, when used with
(four places)
	S-series ice machines
	Screws from kit
Existing two
screws	Drill two 5/32” dia.
Bin	holes each side (use
	adapter as a template to
Hinge	locate holes on bin)

	Important
	Do not drill through
	the inside of the bin
	liner - only through
	outer metal.
Manitowoc Ice, Inc.
2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA
Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879		8009133
Web Site - www.manitowocice.com		Rev. 05/06/04