K00349 ICE DEFLECTOR KIT
Installation Instructions
The K00349, ice deflector kit, must be used with the
1.Remove both front panels.
2.Examine the ice machine to see if the machine has four screws on the lower front plastic panels (see drawing).
3.If there are screws, remove them from the countersunk holes on the front surface of the machine. Save the screws.
4.Install the deflector, using the four screws that were removed in step 3. In some instances, the deflector will hit the bin and not fit properly. Slide the ice machine back (approximately 1/2”) until the deflector fits properly.
5.Four screws and two backing plates are in the kit.
6.If there are no screws on the ice machine (step 2), pierce the thin plastic countersunk holes, install the backing plates, and install the deflector, using the screws from the kit.
7.Replace the front panels.
Backing plate to be inserted into side pocket of bulkhead
| Backing plate to be |
Screws | inserted into side |
| pocket of bulkhead |
If deflector contacts | Screws | |
New Ice Deflector | ||
bin, move ice | ||
| ||
machine back until |
| |
deflector clears. |
|
