INSTALLATION
BRICK FLUE BAFFLE & SECONDARY AIR TUBE INSTALLATION
The fl ue baffl e system located in the upper area of the fi rebox is removable to make cleaning your chimney system easier. The brick baffl es must be installed prior to your fi rst fi re. Smoke spillage and draft problems may occur if the baffles are improperly positioned. Check the position of the brick baffl es on a regular basis as they can be dislodged if too much fuel is forced into the fi rebox.
The Large Stoves F3100L and S3100L are shipped with two of the secondary air tubes looseinsidethefirebox.Theyneedtobeinstalled after the brick baffl e are installed. Follow the directions below.
Large Stoves F3100L and S3100L
The unit arrives with the fi rst two air tubes (from the front) and the 2 baffl e bricks on the fl oor of the fi rebox. The baffl e bricks are positioned fi rst and then the air tubes are installed.
NOTE: If the first 2 airtubes are already installed in the stove, they must be removed in order to install the Brick Baffles.
1)Slide the left baffl e brick over the two rear air tubes and then push it all the way to the left side of the fi rebox.
Side View
2)Tilt the fi rst Baffl e Brick down and then slide the 2nd Baffle Brick up and back. Reposition both baffl e bricks fl at on the air tubes.
3)Important: push both baffle bricks so they are tight against the side walls.
Front View
4)Install the two front air tubes into the holes on the side channels. The notch goes on the right hand side with the air holes facing forward toward the door opening. If the tube will not slide in easily, simply use a pair of vise grips or pliers and tap it into place with a hammer. A tighter fi t will ensure the tube will not move when the unit is burning.
Note: When cleaning the chimney reverse the above procedures, removing the air tube and baffle bricks and then replace them when cleaning is completed.
Small Stoves F1100S
1)If the two air tubes are installed continue on toStep2),ifnot,followtheinstructionsbelow. Install the air tube into the holes in the side channels. The notch goes on the right hand side with the air holes facing toward the door. Slide the tube into the left hand side, as far as possible and then bring it back into the hole on the right hand side until it locks into position. If the tube will not slide in easily simply use a pair of vise grips or pliers and tap it into place with a hammer. A tighter fi t will ensure the tube will not move when the unit is burning. Refer to the Mobile Home Installation section, though there are only two air tubes in the small units.
2)Slide the left baffl e brick over the front air tube and then slide it back over the rear air tube.
Side View
3)Tilt the left baffl e brick up on top of the side channel and it will leave enough room to position the right baffl e brick in the same manner as Step 1 above. Then reposition the left baffl e brick fl at on the air tube.
Front View
4)Important: push both baffle bricks so they are tight against the side walls.
Front View
Note: When getting the chimney cleaned, remove the baffle bricks for access to the flue, then replace them when cleaning is completed.
16 | Regency Freestanding Woodstove |
