![](/images/new-backgrounds/1025792/2579219x1.webp)
INSTALLATION
STOVE ASSEMBLY
PRIOR TO
INSTALLATION
All units require either the pedestal or 4 legs at- tached to the base.The F1100 and F3100 stoves require either theAirmate or Rear Heat Deflector on top of the stove. Clearances to combustible materialsvarydependingonwhethertheairmate or rear heat defl ector is installed, so be sure to check the Minimum Clearance to Combustible Materials section.
Airmate Assembly for F1100 & F3100
Small |
|
Large |
|
1)The airmate sits on top of the stove with the slots in the sides fi tting over the curved defl ector on the rear stove top. See diagram 1. Discard the Rear Heat Defl ector that is supplied with the unit, it is not required if the airmate is installed.
2)Center the airmate and push it forward to the front of the stove. The back of the airmate should be level with the back and sides of the rear heat shield. See Diagrams 2 & 3.
Rear Heat Deflector Assembly
for F1100 & F3100
Small |
|
Large |
|
The rear heat deflector is supplied with the stove and must be installed unless the optional airmate hasbeenselected.Itstopstheheatradiatedfrom the flue collar from overheating the rear wall.The rear heat defl ector is installed on top of the rear heat shield, as shown in Diagram 4.
Diagram 4
S3100L Side Shield Adjustment
The left and right side shields are lowered for shipping and handling. It allows for a handhold on the top of the stove. Before placing in the Step Stove in its fi nal position, the side shields must be raised.
Loosen the screws on the rear on the stove (3 per side), slide the side panel up as far as possible and then secure by tightening the screws.
Pedestal Assembly
Small | |
Large |
1)For easier assembly, tip the stove on its back (onto a soft surface to prevent scratch- ing).
Hint: If you have chosen the Ash Drawer option, remove the ash dump cover plates before attaching the pedestal (refer to the Ashdrawer Kit Installation section).
2)Remove the blanking plate if:
a)youarenotinstallingoutsidecombustion air or
b)outside air is to be brought in from the rear of the stove.
3)Unscrew the 4 bolts in the
Diagram 1
4) Push the Regency logo
into the two holes in
the front bot-
tom left corner of the pedestal
cover plate.
Diagram 2 | Note: Any paint touch up should be done |
| |
| prior to placing logo on pedestal. |
| 5) If not using ash drawer, then cover plate must |
| beinstalled.Ifusingashdrawer,thendisregard |
Diagram 3 | cover plate. |
10 | Regency Freestanding Woodstove |