CONNECTING YOUR AMPLIFIER
Setting up your amplifier is rather easy.
1.Connect all LINE LEVEL source components (CD, Tuner, Tape, DAT, etc.) to the designated RIGHT & LEFT inputs on the back of the amplifier.
2.Connect the hot or "+" speaker cable to the red binding post and the common or
3.Check that the volume control is in the minimum counter clockwise position and/or the MUTE switch is engaged DOWN.
4.Ensure that the "mains" switch on the front panel is in the "off" or "DOWN" position.
5.Turn on any source components you plan to use first.
6.Plug amplifier into wall outlet.
7.Switch the mains power switch to the ON position and allow the amplifier a minute or so to 'warm up'.
8.If the MUTE switch is engaged, the red mute LED will illuminate. Throw this switch UP to the operateposition.
9.Turn up the volume and enjoy.
10.After your listening session, be sure to mute the amplifier and turn off the power BEFORE powering down any source components. You do not want to amplify potential noises your source components may create on