III. Safety Decal Information | An important part of the safety system incorporated in this tiller |
| are the warning and information decals found on various parts of the |
tiller. These decals must be replaced in time due to abrasion, etc. It is your | |
responsibility to replace these decals when they become hard to read. The | |
| location and part numbers (P/N) of these decals are illustrated below. |
P/N 400634
P/N 400631
CUTTING HAZARD; KEEP FEET AND HANDS AWAY FROM ROTATING TINES.
DO NOT CARRY THE TILLER IN THIS POSITION.
READ OWNER’S MANUAL BEFORE USING TILLER, OR PERFORMING ANY REPAIR OR MAINTENANCE. KEEP OWNERS MANUAL IN A SAFE PLACE.
DON’T FUEL, REFUEL, OR CHECK FUEL WHILE SMOKING, OR NEAR AN OPEN FLAME OR OTHER IGNITION SOURCE.
P/N 400635 |
DO NOT REACH YOUR FINGERS AND\OR HANDS IN BETWEEN THE TINE BLADES
ALWAYS REMOVE THE OUTER TINES BEFORE REMOVING THE INNER TINES
CAUTION: WHEN ASSEMBLING THE HANDLES, MAKE SURE FUEL TANK FACES AWAY FROM OPERATOR. THIS IS THE REAR OF THE TILLER, REFER TO ASSEMBLY INSTRUCTION ON PAGE 7.
INCORRECT ASSEMBLY.
WEAR EAR AND EYE PROTECTION.
DO NOT OPERATE TILLER INDOORS OR IN POORLY VENTILATED AREA
! WARNING • DANGER !
IF THE TILLER IS USED IMPROPERLY OR SAFETY PRECAUTIONS ARE NOT FOLLOWED, THE USERS RISK SERIOUS INJURY TO THEMSELVES AND OTHERS. READ AND UNDERSTAND THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS TILLER.
! WARNING • DANGER !
OPERATION OF THIS EQUIPMENT MAY CREATE SPARKS THAT
CAN START FIRES AROUND DRY VEGETATION. A SPARK
ARRESTOR IS INSTALLED. THE OPERATOR SHOULD CONTACT
LOCAL FIRE AGENCIES FOR LAWS OR REGULATIONS RELATING TO FIRE PREVENTION REQUIREMENTS.
IV. Warnings - Do’s
Read and understand the owner’s manual. Pay particular attention to all sections regarding safety.
1.Always keep a firm grip on both handles while the tines are moving and/or the engine is running. BE AWARE!! The tines may coast after throttle trigger is released. Make sure tines have come to a complete stop and engine is off before letting go of the tiller.
2.Always maintain a firm footing and good balance. Do not overreach while operating the tiller. Before you start to use the tiller, check the work area for obstacles that might cause you to lose your footing, balance or control of the machine.
3.Thoroughly inspect the area where equipment is to be used and remove all objects, which can be thrown by the machine.
4.Always keep area clear of children, pets, and bystanders.
5.Always stay alert. Watch what you are doing and use common sense. Do not
operate unit when fatigued.
6.Always dress properly. Do not wear loose clothing or jewelry, they might get caught in moving parts. Use sturdy gloves. Gloves reduce the transmission of vibration to your hands. Prolonged exposure to vibration can cause numbness and other ailments.
7.While working, always wear substantial footwear and long trousers. Do not operate the equipment when barefoot or wearing open sandals.
8.Always wear ear and eye protection. Eye protection must meet ANSI Z 87.1. To avoid hearing damage, we recommend hearing protection be worn whenever using the equipment.
9.To reduce fire hazard, keep the engine, and petrol/gas storage area free of vegetative material and excessive grease.
10.Start the engine carefully, according to the manufacturer’s instructions and with feet well away from tool(s).
11.Keep all nuts, bolts and screws tight to be sure the equipment is in safe
working condition.
12.Use extreme caution when
reversing or pulling the machine towards you.
13.Work only in daylight or good artificial light.
14.Always be sure of your footing on slopes.
15.Exercise extreme caution when changing direction on slopes.
16.Always keep a safe distance between two or more people when working together.
17.Always inspect your unit before each use and ensure that all handles, guards and fasteners are secure, operating, and in place.
18.Always maintain and examine your tiller with care. Follow maintenance instructions given in manual.
19.Always store tiller in a sheltered area (a dry place), not accessible to children. The tiller as well as fuel should not be stored in a house.
20.Always remove the outer set of tines before removing the inner set of tines.
4
