Mantis 401764 XP owner manual How To Assemble Lower Handles, Assembly continued

Assembly (continued)

HOW TO ASSEMBLE LOWER HANDLES

To identify part numbers, see pages 6 and 18.

1.Open the protective cardboard sleeve, but leave the engine assembly (#21) in this cradle to stabilize it during assembly. (Picture 1)

2.Lay the handle parts within easy reach. You’ll need one of the handle clamps (#51) and one of the lower handles (#6). Note that the lower handles have a short leg on one end.

3.Fit the handle clamp along the outside of the short leg. Line up the holes on the clamp and the leg.

4.Choose one of the two 3-inch bolts (#49). Slide it through the first set of holes — near the elbow where the lower handle curves. (Picture 2)

5.Now slide the other lower handle onto the 3-inch bolt. Fit the

other handle clamp onto this other handle’s short leg. Add a nut (#48) and tighten finger tight. (Picture 3)

6.Locate the worm gear housing. It starts just above – and extends down through – the tiller’s red fender guard. You’ll notice that there’s a recessed channel on either side of the housing’s top. (Picture 4.)

7.Take the lower handles that you’ve just put together. Slide them into the two recessed channels.(Picture 5.)

Make sure you insert them from the rear of the tiller (gasoline tank faces away from the operator)... so that the bolt fits along the back of the housing.

8.Slide the second 3-inch bolt through the second set of holes in the short legs. Add a nut and tighten finger tight.

Picture 1

NOTE: THE LOCK NUTS ARE STAMPED. FINGER TIGHT IS

APPROXIMATELY 1/2 TO 1-1/2 TURNS.

Picture 2

Picture 3 Picture 4 Picture 5

7