Marantz DV4100 Before requesting service, SymptomRemedy, English, No power, No picture, Settings

Before requesting service

If it appears that the DVD-Video player is faulty, first consult this checklist. It may be that something has been overlooked. Under no circumstances attempt to repair the system yourself; this will invalidate the warranty.

Look for the specific symptom(s). Then perform only the actions listed to remedy the specific symptom(s).

SymptomRemedy

ENGLISH

No power	Make sure the AC cord is properly connected.
	Check if there is power at the AC outlet by plugging in another
	appliance.
No picture	Check if the TV is switched on.
	Check the video connection.
Distorted picture	Check the disc for fingerprints and clean with a soft cloth, wiping from
	center to edge.
	Sometimes a small amount of picture distortion may appear .This is
	not a malfunction.
Completely distorted picture	If the picture is distorted completely or if the picture rolls vertically,
or no color with player menu.	make sure the NTSC/PAL setting at the DVD player matches the video
	signal of your television.
	If your TV video signal is NTSC, select the NTSC setting at the DVD player.
	If your video signal is PAL, select the PAL setting - see NTSC/PAL
	SETTINGS.
Distorted or Black/White picture with DVD	The disc format does not match your TV’s video signal (PAL/NTSC).
or Video CD.
No sound	Check audio connections.
	If you are using a amplifier, try another sound source.
Distorted sound from amplifier.	Check to make sure that no audio connections are made to the amplifier
	phono input.
No audio at digital output.	Check the digital connections.
	Check the settings menu to make sure the digital output is set to ALL
	or PCM.
	Check if the audio format of the selected audio language matches
	your receiver capabilities.

Disc can’t be played.

Ensure the disc label is facing up. Clean the disc.

Check if the disc is defective by trying another disc.

Check to see if the disc is defective, badly scratched or warped (not flat)

No return to start-up screen when	Reset by switching the player off, then on again.
disc is removed.	Check to see if the program requires another disc to be loaded.
The player does not respond to	Aim the remote control directly at the sensor on the front of the player.
the remote control.	Remove any obstacles between the player and the remote control.
	Inspect or replace the batteries in the remote control.
Buttons do not work.	In order to completely reset the player, unplug the AC cord from the AC
	outlet for a few seconds.
Player does not respond to all operating	Operations are not permitted by the disc. Refer to the instructions of
commands during playback.	the disc.
DVD-Video player cannot read CDs/DVDs	Use a commonly available cleaning CD/DVD to clean the lens before taking
correctly.	the DVD-Video player to be repaired.

BEFORE REQUESTING SERVICE 33