Marantz MAR0076 To select connected equipment, VGA menu, If you want to change to TV channels?

TV

1 2 3

4 5 6

7 8 9

i+ 0 PP

Keypad

1/9 Sub + Sub -

TV

1VGA

2 Front

3Scan

Go back

8/9 Sub + Sub -

MUTE

CHANNEL

VOLUME

MUTE

CHANNEL

VOLUME

English

To select connected equipment

If the monitor is connected to a video recorder with the EasyLink function, in some cases the monitor will be switched on, even when it was in standby. (E.g. playback tape,...)

This is not possible when Child lock On is selected.

Equipment connected with an aerial cable only :

Select the programme number under which you have stored the test signal with the digit keys.

Equipment connected to a euroconnector, to the VGA MONITOR IN connector or to the front side of the receiver box

Press the w key to select EXT1, EXT2, EXT3, FRONT or VGA, according to where you connected your equipment at the back or the front side of your receiver.

Remark : Most equipment (decoder, video recorder) carries out the switching itself.

If you want to change to TV channels?

Enter the programme number of the TV channel which you want to watch with the digit keys.

VGA menu

&Press the w key in the “keypad” control panel and select VGA.

ŽSelect in the control menu “cursor”

ÒPress the red (picture menu), green (sound menu) or yellow (features menu) key on the door of the remote control to switch on the VGA menu

(or press the MENU key on the simplified remote control).

ÔSelect one of the PC symbols with the cursor up/down:

H for contrast,

G for brightness,

for colour temperature,

for horizontal picture position,

for vertical picture position,

(Press the cursor left/right to alter the selected adjustment.

¤Press one of the coloured keys again (or the MENU key on the simplified remote control) to switch off the VGA menu.

Connect peripheral equipment 1-23