NAMES AND FUNCTIONS OF PARTS
FRONT PANEL
q w e | r | t | y | u |
ENGLISH
!4 !3 !2
qPOWER SWITCH
Pressing once switches the power ON, and pressing again switches it OFF.
If the POWER switch is in the ON position, the power of this unit can be turned ON/OFF by pressing the POWER button on the remote control unit.
wSTANDBY INDICATOR
Lights up when the unit is in the standby mode.
eINPUT SELECTOR
Selects the program source to be recorded or played from the PHONO, CD, TUNER, AUX/DVD, RECORDER 1
rTONE DEFEAT SWITCH
•When the switch is not depressed, the audio signals are applied to the tone control circuit and the tone can be adjusted using the tone control knob.
•When the switch is depressed, the audio signals bypass the tone control circuit and the balance control circuit. Then, the tone control knob and the balance control knob do not function.
tFUNCTION INDICATORS
One of the indicators lights up to indicate the input source selected with the INPUT SELECTOR.
yMUTING INDICATOR
Light up when the MUTING button in the remote control unit is pressed.
NOTE:
Be sure to check the VOLUME control setting before pressing this switch to cancel muting. If the muting is canceled while the volume setting is high, the speakers could be damaged.
uVOLUME CONTROL
Adjusts the volume level. Turn the knob clockwise to increase the volume.
!1 !0 o i
iLOUDNESS SWITCH
The LOUDNESS switch compensates for human hearing characteristics by boosting the bass and treble response at low volume levels to achieve a more pleasing tonal balance.
oSPEAKERS 1 / 2 SWITCHES
These switches are used to select the speaker system(s) connected to the SPEAKER SYSTEM 1 / 2 terminals on the rear panel. If both the 1 and 2 switches are pressed to the low positions, two speaker systems can be used at the same time.
When headphones are used for listening, set both switches 1 and 2 to OFF (high positions).
!0BALANCE CONTROL
Turn the knob to correct an unbalanced program source such as stereo broadcast or to vary the output level of the left or right channel. Note that, if the BALANCE control is turned fully in one direction, the sound will not be heard from the speaker on the other side.
!1BASS AND TREBLE TONE CONTROLS
Adjusts the tone by controlling the levels of two frequency bands. Turn each control toward (+) to enhance the corresponding frequency band, or toward
TREBLE: Adjusts the high frequency level.
BASS: Adjusts the low frequency level.
!2REC SELECTOR SWITCH
Selects the tape dubbing mode between tape decks or the signal output at the REC OUT jacks.
!3REMOTE SENSOR
The remote sensor receives the infrared commands from the remote control unit. When an infrared signal is received from the remote control unit. The remote control unit must always be pointed directry at the remote sensor.
!4PHONES JACK
Insert the standard phone plug of the headphones into this jack.
4
