Marantz PM4001 USING THE REMOTE CONTROL UNIT Remote control, Loading batteries, English, Recorder

NAMES AND FUNCTIONS OF PARTS

c. SOURCE POWER button

Switching the mode of a CD player, tuner, CD-R or other Marantz component equipped with a power standby function between power-on and standby is enabled by pressing this button after the FUNCTION SELECT button corresponding to the component has been pressed.

When this button is pressed after pressing the TUNER button, the tuner’s power is turned on; when it is pressed again, the tuner is set to the standby mode.

When this button is pressed after pressing the AMP button, the PM4001 is switched from the power-on mode to the standby mode or vice versa.

xFUNCTION SELECT button

PHONO button : When this button is pushed the input of PHONO is selected.

CD button : When this button is pushed the input of CD is selected.

TUNER button : When this button is pushed the input of TUNER is selected.

RECORDER 1

(CD-R)button : When this button is pushed the input of CD-R is selected.

AUX button : When this button is pushed the input of

AUX/DVD is selected.

DVD button : When this button is pushed the input of

AUX/DVD is selected.

RECORDER 2

(TAPE) button : When this button is pushed the input of MD/TAPE is selected.

(MD) button : When this button is pushed the input of MD/TAPE is selected.

CAUTION:

A pair of input jacks is used as the common input jacks for the MD or TAPE input and another pair is used as the common input jacks for the DVD or AUX input. The reason an independent button is used for each input is that the codes used by the RC4001PM to control the MARANTZ MD recorder, tape deck and DVD recorder are different.

cVOLUME UP/DOWN button

UP button : VOLUME knob turns when this button is pushed and the volume level is grows.

DOWN button : VOLUME knob turns when this button is pushed and the volume level is falls.

vMUTE button

When this button is pushed, the sound is not temporarily emitted from the speakers.

When this button is pushed again, MUTE is released. Moreover, when up/down of the volume is operated by remote control, MUTE is released.

Other buttons are not applied to PM4001.

Please see at the owners manual of other equipment’s about the operation of button.

USING THE REMOTE CONTROL UNIT

￿Remote control

Operate the remote control unit within a distance of approx. 5 m from the infrared signal reception window (remote sensor) on the front of the Amplifier.

Remote control operation may not be possible if the remote control unit’s transmitter is not pointing in the direction of the remote sensor or if there is an obstruction between the transmitteote sensor.

Remote control operating range

Amplifier

Approx. 5 m

60°

Remote control unit

￿Loading batteries

Before using the supplied remote control unit for the first time, load the batteries in the remote control unit. The batteries pro- vided are used to verify the operations of the remote control unit only.

(1) Remove the battery cover.

Remote control unit

Rear side

(2) Insert batteries with correct ª/· orientation.

Two “AA” size batteries

(3) Close the battery cover until it clicks shut.

ENGLISH

6