ENGLISH
BASIC OPERATION
OPERATION PROCEDURES | RECORDER OPERATION |
Operate each equipment to start play.
REC SELECTOR
Control used for operating the tape deck.
TO PLAY AN ANALOG DISC
1.Set the INPUT SELECTOR switch q to PHONO.
2.Play a disc on the turntable.
3.Adjust the volume with the VOLUME control w and adjust the tone with the BASS and TREBLE controls e.
NOTES:
•Set the VOLUME control to the minimum position before placing the stylus on the disc or before replacing the cartridge.
•Do not apply shock or vibration to the turntable during play, as this may cause the stylus to jump and the analog disk to be damaged.
•If the turntable is installed too close to the speakers, the volume may not be able to be increased to a high level due to howling.
•Do not switch the power OFF while the stylus is on the disc surface.
TO LISTENTO FM/AM BROADCASTS
1.Set the INPUT SELECTOR switch q to TUNER.
2.Tune in the desired station on the tuner.
3.Adjust the volume with the VOLUME control w and adjust the tone with the BASS and TREBLE controls e.
TO PLAY A DVD OR COMPACT DISC
1.Set the INPUT SELECTOR switch q to CD.
2.Play a CD on the CD player.
3.Adjust the volume with the VOLUME control w and adjust the tone with the BASS and TREBLE controls e.
TO PLAY A DVD OR COMPONENT CONNECTED TO AUX/DVD JACKS
The component connected to the AUX/DVD jacks on the rear panel can be played as follows.
1.Set the INPUT SELECTOR switch q to AUX/DVD.
2.Play the component connected to the selected input.
3.Adjust the volume with the VOLUME control w and adjust the tone with the BASS and TREBLE controls e.
PLAYBACK
1.Set the INPUT SELECTOR switch A to RECORDER 1
2.Play a prerecorded disc or tape on the recorder.
3.Adjust the volume with the VOLUME control B.
4.Adjust the tone with the BASS and TREBLE controls C.
RECORDING
The playback sound of a program source component, such as a turntable, a tuner, or a CD player, can be recorded on disc or tape as followss.
1.Set the INPUT SELECTOR switch A to the program source to be recorded.
2.Play the program source.
3.Operate the recorder(s) to record the playback sound on disc(s) or tape(s).
Using REC SELECTOR switch
The REC SELECTOR switch is used when copying a recorded disc or tape to another disc or tape, or recording a CD onto a recordable disc or cassette tape.
1.When the switch is in the OFF position, the signal is not output at the REC OUT jacks.
It is not necessary to output the signal at the REC OUT jacks when the signal is not recorded onto disc or tape. By setting the switch to OFF, the signal path inside the unit can be shortened and crosstalk, etc., can be reduced.
2.In the SOURCE position, the signal selected with the INPUT SELECTOR switch can be recorded onto disc/tape.
3.In the COPY positions, the RECORDER 2 (MD/TAPE) signal can be recorded onto RECORDER 1
4.In the COPY position, the program source selected with the INPUT SELECTOR switch can be monitored through the speakers.
7
