Marantz PM7001KI Before Use, 7EQUIPMENT MAINS WORKING SETTING, 7COPYRIGHT, 7Keep Objects Off

BEFORE USE

This section must be read before any connection is made to the mains supply.

7EQUIPMENT MAINS WORKING

SETTING

Your Marantz product has been prepared to comply with the household power and safety requirements that exist in your area.

PM7001 can be powered by 230V AC only.

7COPYRIGHT

Recording and playback of any material may require consent. For further information refer to the following:

—Copyright Act 1956

—Dramatic and Musical Performers Act 1958

—Performers Protection Acts 1963 and 1972

—Any subsequent statutory enactments and orders

7Do Not Locate in the Following

Places

To ensure long-lasting use, do not locate the PM7001 where:

•Exposed to direct sunlight.

•Near to sources of heat such as heaters.

•Highly humid or poorly ventilated.

•Dusty.

•Subjected to mechanical vibrations.

•On wobbly, inclined or otherwise unstable surfaces

•Radiated heat is blocked such as in cramped audio racks. To ensure proper heat radiation, ensure the below clearance from walls and other equipment.

Left	Above	Right
0.2 m or more	0.2 m or more	0.2 m or more
INTEGRATED AMPLIFIER PM7001

Rear 0.2 m or more

7Keep Objects Off

Keep objects off the PM7001. Blocking the vent can result in accident and damage.

7Do Not Touch Hot Spots During

and Immediately After Use

During and immediately after use, the PM7001 is hot in areas other than the controls and rear panel connection jacks. Do not touch hot spots and especially the top panel. Contact with hot areas can cause burns.

7Battery Handling

Improper use of dry cell batteries can result in electrolyte leaks, rupture and corrosion. Read the following precautions before use.

•If not planning to use the remote controller for an extended period of 1 month or more, remove the batteries.

•Do not mix old batteries with new batteries.

•Load batteries in the proper direction indicated on the re- mote controller.

•Do not mix batteries of differing type. Even batteries of the same shape and size can have differing voltages.

•If batteries leak, wipe the case clean of any adhering elec- trolyte and replace the old batteries with new batteries.

7Accessories Check

Before use, check the below accessories were included in the package.

• AC power cable

The power cable included in the package can be used with the PM7001 only. It cannot be used with other equipment.

•RC4001PM remote controller

•AA-size batteries x 2

•Registration Card

•User Guide (This manual)

ENGLISH

1