RX8001 User Guide
Configuring the Extender
Note Before you start configuring the Extender, check for firmware updates in the Downloads section on http://www.marantz.com in the Home Entertainment section of your region.
Refer to the chapter ‘Firmware Update’ on page 9 for further details.
Stand-alone Connection
To configure the
1Plug in the Extender’s power adapter.
The Extender will start up. When
2Use the default switch settings of the Extender:
|
|
| ||
|
| Configuration switch | 1 |
|
|
| Extender ID | 0 |
|
|
|
|
|
|
|
|
|
|
|
Note • If there is already an Extender with ID 0, set the Extender ID switch to an ID that is not used yet.
•If there is any interference with other products in or around the house, the Configuration switch can be set to a different RF channel.
•Make sure the same Extender ID and RF channel are used on the Extender and the Control Panel.
3Configure the Control Panel’s configuration file so that the Control Panel can work with the Extender. For more details, refer to the Wizz.it Ex Online Help.
Network Connection
In the case of a network connection, the Extender is made part of the wireless | Network. | ||
There are two ways to use the Extender in a network: |
|
| |
• Wired connection |
| Straight Ethernet Cable |
|
| Extender |
|
|
|
| Control Panel | |
| Router |
|
|
| Wireless |
|
|
| Access Point |
| |
• Wireless connection |
|
|
|
| Extender | Control Panel | |
|
| ||
| Wireless |
|
|
| Access Point |
|
|
Note When you set up a Wireless 
Network connection, make sure the Control Panel always shows minimal one bar of WiFi connectivity. If this is not the case, you may need additional Wireless Access points in your network.
ENGLISH
4
