OPERATION
*In this instruction manual, some operations can only be performed with the remote control. For operations that can be
performed with buttons both on the main unit and on the remote control, the button names are shown in the 
mark. And for operations that can only be performed with buttons on the remote control, the button names are shown in the 
mark.
ENGLISH
CONNECTING THE POWER SUPPLY
1Plug the power cable into AC IN jack on the back panel.
2Turn on the power switch of the audio unit (amplifier, etc.) that is connected with this unit. Set the selector on the connected unit to this unit.
3Plug the power cable into an AC outlet.
NORMAL PLAYBACK
7Super Audio CD player playback
OPEN/ | SUPER AUDIO CD PLAYER |
|
|
CLOSE |
|
| PLAY |
| DISPLAY OFF |
|
|
|
|
| STOP |
SOUND | POWER ON/OFF | PHONES | LEVEL |
MODE |
|
| PAUSE |
|
| - | + |
w, e q r
qPress POWER switch to turn on.
LCD
The display cycles from TOC Reading → No Disc (when no disc is loaded) → Super Audio CD (when the start sound mode setting is Super Audio CD).
wPress the 
OPEN/CLOSE button
The disc tray comes out. Place the disc with label side up on the tray.
To play a single (8cm) CD, place the disc with the indentation at the center of the tray.
ePress 
OPEN/CLOSE button.
rPress 
PLAY button.
Disc type is automatically detected and playback is started. Track number and track elapsed time(minute, second) appear on the display.
*For Super Audio CD/CD
13)is played. To change the layer, use the SOUND MODE button. (See page 12)
(Exp.:Track 6, Elapsed time 2 min 8 sec)Number of current track | Minutes Seconds |
Remaining track numbers
Playback automatically stops at the end of the final track.
11
