NAME AND FUNCTION
FRONT PANEL
r
| stereo control | amplifier sc - 7s2 |
|
|
BALANCED |
|
|
|
|
CD |
|
|
|
|
| A | SYNC B |
|
|
LINE 1 |
|
|
|
|
LINE 2 | power on/off | DISPLAY | ATT | |
RECORDER |
|
|
|
|
i n p u t selector |
|
|
| volume |
e | w | q | u y | t |
DISPLAY SECTION
I
II
A SYNC B
IVIII
qPower switch
The switch is used to Power the unit ON and or OFF. Once the unit is powered On, the indicator of the Input Selector will illuminate for the source selected. The
wRemote control sensor
This is the IR (Infra Red) window which receives IR control signals being sent from the remote controller.
How to use remote control → p.14
tVolume knob
The Volume knob is used to increase & decrease the overall volume level. By turning the Volume Knob clockwise, the volume will be increased. By turning the Volume Knob counter
yATT (Attenuation) button, indicator
The ATT button is used to reduce the volume quickly, with just one touch. Once the button is pressed, the volume will
I Power indicator
This Indicator is to show if the power is on. When power is on, the blue light will be illuminated.
II Volume indicator
This will display the volume level and changes made to the volume with either the remote controller or the Volume Knob on the face of the unit. After 3 seconds of being pow- ered on, the ID number will be displayed. The ID number is
changed by the ID switch on the rear panel of the unit. If the attenuate function or trim adjustment is being used, the levels will also be indicated. If using several
Error message → p20
III A/B CH Indicator
During trim adjustment, the indicator lights will be illumi- nated in accordance to the adjustments.
See Trim adjustment → p17
eInput selector knob
The input Selector Knob will determine what source is being played as well as well as able to be recorded. When the Source is selected, the Blue indicator will be illuminated to verify the source selected. When the unit is powered down, the last selected source will be held in memory. When the unit is powered on again, the last selected source will be selected. When RECORDER is selected, there will be no signal output, to the record output.
rDisplay section
Displays the settings & volume level.
be decreased. The Volume Display will begin blinking & the Volume Indicator above the ATT button will illuminate. If you press the ATT button again, the Volume Display will stop blinking & display the Volume level. You can decrease the volume by 20dB, 40dB & 60dB. Please refer to page 16 for further information regarding Attenuation functions.
uDisplay button, indicator
This button is to turn off the Volume Indicator & the Light for the Volume Indicator. If the volume Indicator & light are on, and you press this button, they will both be turned off. Also, the light above this button will be illuminated. If you make any adjustment the Volume Indicator & Light will come on for 3 seconds, then shut off again. If you press this but- ton again, the Volume Indicator & Light will be turned on and the light above this button, will shut off.
max. | 00.0 dB |
| |
|
0.5 dB step
min. | - ∞� |
|
Turn the volume knob
▲button of the remote controller.
Turn the volume knob counterclockwise or press volume ▼ button of the remote controller.
IV SYNC (Synchronized) Indicator
The indicator will be illuminated in accordance with the ID number setting.
•Green color illuminated: ID No. is set up <1>.
•Red illuminated:
ID No. is set up
•Light off:
There is an error in the remote connections.
•Green or Red color will be flashing: While trim is being adjusted.
When you use the remote control, please face it towards the
12