ENGLISH
Rear panel connections (see pages 5)
All connections to the rear panel should be made with entire power off to the system. To avoid miss- connection, it is advisable to connect one cable at a time between the different components. This is the safest way to avoid
AAntenna terminal
FM antenna terminal
For connecting an external FM antenna with a coaxial cable, or for connecting a cable network.
AM antenna and ground terminal
For connecting the supplied AM loop antenna. Use the terminals marked “AM” and “GND”.
The supplied AM loop antenna will provide good AM reception in most areas. Position the loop antenna to the best reception.
BPHONO INPUT jacks
Connect the output jacks of a turntable to these jacks.
CAUX(TV) INPUT jacks
Connect to the TV’s (or other equipment) audio out jack.
DTAPE input/output jacks
Connect the output (play) jack of the cassette deck to the IN jack, and connect the input (REC.) jack to the OUT jack.
ECD input jacks
Connect to the CD’s audio out jack.
FREMOTE jacks
Connect to other Marantz components equipped with REMOTE jacks. (see page 9)
Marantz components utilize the Philips
GPRE OUT jacks
These jacks supply
(if necessary)
HSPEAKER terminals
Connect to the L or R channel speakers.
IAC outlets
Connect the AC power cable of a CD player, cassette deck, etc., of your system. The power supply from switched outlet is interlocked with the POWER switch of the receiver.
The maximum total power consumption of the connected components must not exceed the following limit :
120 WATT MAX. TOTAL
JAC power cord
Plug into AC120V household outlet.
Note on loudspeaker impedance :
The power ratings specified for this Marantz receiver are obtained using fixed value test load impedance.
However, the actual impedance of a loudspeaker system will vary with frequency, deviating from the nominal rating.
This Marantz receiver will drive any modern loud- speakers system with a rated impedance of 8 ohms or higher.
A few newer loudspeakers feature impedance of less than 8 ohms. The high current output capability of this Marantz receiver can provide the additional power necessary to drive such low impedance speakers.
However, during extended passages of high volume, the protection circuitry may temporarily interrupt operation.
If this occurs, simply reduce the volume accordingly. The protection circuitry is specially designed so that it cannot affect the sound quality during normal operation.
8