LFE ATT (LFE attenuater)
Select the output level of the LFE signal included in the Dolby Digital
signal or the DTS signal. Select 0dB, 
or 
button.
The level is ordinarily set to 0 dB. When use DTS Music source, LFE level is set to
DIG IN (Digital input)
Four digital inputs can be assigned for the desired source.
Use this menu to determine which source is connected to which input.
Example;
When the digital output of a DVD player is connected to Digital 4 (input jack) of the SR4200;
1.Select “DIG IN” with cursor buttons 
or 
and press the OK or 
button.
2.Select “DIGITAL4” with cursor buttons 
or 
and press the OK or
button.
3.Select “D4/DVD” with cursor buttons 
or 
and press the OK or 
button.
4. If you desire to continue the next setup, press the and 
or 
button. If you desire to exit from menu system, press the MENU OFF button.
Notes:
The TUNER is assigned to the analog input, and are prevented from selecting any digital input.
While the
The SR4200 does not switch from digital input to analog input or vice versa automatically.
In the event that both digital and analog inputs are connected to SR4200, if you desire to switch to an analog input temporarily, you can switch by pressing the A/D button y.
TEST MODE
When you press the T.TONE ¤1, the test tone will be cycled through in a circular pattern which is FL (front left) → C (center) → FR (front right)
→RS (right surround ) → LS (left surround) → SW (subwoofer) → FL
→... 3 seconds for each channel.
Adjust the level of test tone for each channel with the 
or 
buttons of the RC5200SR
ENGLISH
11
