SR6001 |
Page: 3 / 19
Document Version [1.00]
1.Introduction
1-1. Purpose
This document was written as a reference specification of products that are controled by the host controller.
1-2. Scope
This document would be using by software or hardware engineers for production of the product.
1-3. Abbreviations
Abbreviation
Description
1-4. References
Hardware Software Interface Specification ver. 1.02 / author: N.Sakamoto
2.Global Description
2-1. Overview
A Host controller can control or watch out the product as a Slave very easily via the communication cable.
2-2. Block Diagram
HOST
(Controller)
RS232C cable (Straight)
SLAVE
(The product) Connector
*The product connector is using D-SUB 9pin male.
*RS232C cable must use
uP Interface | Signal name | Connection device |
| Connecter |
- | N.C. | - | 1 | <The product connector> |
|
|
|
| RS232C |
UART | TxD (output) | RS232C | 2 | |
| Level shift driver |
|
| |
RxD (input) | 3 |
| ||
|
| |||
- | N.C. | - | 4 |
|
- | GND | GND | 5 |
|
- | N.C. | - | 6 |
|
- | N.C. | - | 7 |
|
- | N.C. | - | 8 |
|
- | N.C. | - | 9 |
|
2-4. Assumptions and Dependencies
Company Restricted