Additional Information
Screen Saver
The screen saver picture appears when you leave the DVD Player in stop mode for about five minutes.
After the Screen Saver has been engaged for about five minutes, the DVD Player will automatically turn itself off.
Video Mode Setting DVD-V VCD2.0 VCD1.1
With certain discs, the playback picture may be flick- ering or Dot Crawl is shown on straight lines. That means Vertical interpolation or
To change the video mode, press and hold DISPLAY about 3 seconds during disc playback. The new video mode number selected is displayed on the TV screen. Check whether the video quality has improved. If not, repeat the above procedure until picture quality is improved.
Video mode change sequence:
MODE1 → MODE2 → MODE3 → MODE1
If you turn off the power, the video mode will be back to initial state (MODE1).
Detailed Descriptions for Video Modes
MODE1: The source material of the DVD video (film material or video material) is determined from disc information.
MODE2: Suitable for playing film based content or video based material recorded by the progressive scan method.
MODE3: Suitable for playing video based content with compar- atively little motion.
Note
The video mode setting only works when the Progressive Scan mode is set to “On” in the Setup menu.
HDCD Playback
HDCD is a process that increases the fidelity of both specially encoded HDCD discs and standard CD audio discs. When an
To enjoy the benefits of HDCD, your DVD Player must be connected to your A/V receiver via the Analog Audio Outputs. However, if your A/V receiver or surround processor is equipped with
OPERATION
25
