NBE100 User's Manual
2.5.2 Device Label
Program this parameter with a text string which identifies this particular NBE100, to allow you to easily distinguish it from other NBE100’s on the network.
2.5.3 Advanced Configuration…
Certain parameters do not normally need to be set in order for normal operation, but are included in an advanced configuration section for use in special situations.
2.5.3.1 Restore Factory Defaults
Selecting this configuration option causes all stored parameters in the NBE100 to be reset to the values they contained when the unit was manufactured.
3 Maintenance
Regular maintenance is important to ensure continued proper operation of the Maretron NBE100. Perform the following tasks periodically:
•Clean the unit with a soft cloth. Do not use chemical cleaners as they may remove paint or markings or may corrode the NBE100 enclosure or seals. Do not use any cleaners containing acetone, as they will deteriorate the plastic enclosure.
•Ensure that the unit is mounted securely and cannot be moved relative to the mounting surface. If the unit is loose, tighten the mounting screws.
•Check the security of the cables connected to the NMEA 2000® connector, and tighten if necessary.
4 Troubleshooting
If you notice unexpected operation of the Maretron NBE100, follow the troubleshooting procedures in this section to remedy simple problems. If these steps do not solve your problem, please contact Maretron Technical Support (refer to Section 6 for contact information).
Symptom | Troubleshooting Procedure |
No devices on one side | • Ensure that the NBE100 is properly connected to the NMEA |
of the NBE100 are | 2000® network segments. |
visible from a display | • Ensure that both NMEA 2000 network segments have |
connected to the other | power. |
side. | • Ensure that both NMEA 2000 network segments have two |
| termination resistors fitted. |
Page 6 | Revision 1.0 |
